Section 10.1.3.1. Cold gas supply

Two methods are commonly used: generation of gas by boiling liquid N₂ with an electrical heater, and cooling of a gas stream in a liquid-N₂ heat exchanger.

Because precise voltage and current control are easily realized, the boiler method has the advantage of providing very accurate control of the flow rate with minimal effort. Precise control of the flow rate is typically not attained when the rate is controlled with standard gas-flow regulators, because they control volume, not mass.

In addition to control of the flow rate, precise control of the temperature requires exceptional insulation for the cold stream. The longer the stream path, the higher the requirements for insulation. As a rule, temperature rise during transfer should not exceed 15 K at a flow rate of 0.2 mol N₂ min⁻¹; preferably, it should be significantly lower. Higher cooling loss leads to excessive coolant consumption and to instability caused by changes in ambient temperature. High flow rates also tend to cause undesirable cooling of diffractometer parts. No commercially offered device should be accepted if it does not meet the criterion given above.

Appropriate insulation can be readily attained either with silvered-glass Dewar tubing or with stainless-steel vacuum tubing. Glass has the advantage of being available from local glassblowing shops; it generally provides excellent insulation. The main disadvantages are fragility and a rigid form that makes accurate positioning of the cold stream difficult. Stainless steel can provide superb insulation, given an experienced manufacturer; unsatisfactory insulation is quite common. A major advantage is the availability of flexible transfer lines that greatly simplify the positioning of the cold stream relative to the diffractometer.