modify your search
 Results for DC.creator="B." AND DC.creator="H." AND DC.creator="Toby" in section 3.3.9 of volume G
Multiple sets of measurements and phases
Toby, B. H.  International Tables for Crystallography (2006). Vol. G, Section 3.3.9.4, p. 129 [ doi:10.1107/97809553602060000735 ]
... shown in the CIF in Example 3.3.7.1. The program GSAS2CIF (Toby et al., 2003) can create CIFs for multiple sets of measurements and phases. References Toby, B. H., Von Dreele, R. B. & Larson, A. C. (2003) ...

One phase, multiple sets of measurements
Toby, B. H.  International Tables for Crystallography (2006). Vol. G, Section 3.3.9.3, p. 129 [ doi:10.1107/97809553602060000735 ]
One phase, multiple sets of measurements 3.3.9.3. One phase, multiple sets of measurements It is fairly common to use more than one diffraction data set to determine a model for a single phase. Some examples include: combined refinement using both neutron and X-ray powder diffraction; use of multiple X-ray ...

Multiple phases
Toby, B. H.  International Tables for Crystallography (2006). Vol. G, Section 3.3.9.2, pp. 128-129 [ doi:10.1107/97809553602060000735 ]
Multiple phases 3.3.9.2. Multiple phases When more than one phase is present, multiple CIF blocks are needed. The resulting CIF will contain much the same information as would be found in a single-phase pdCIF, as described in Section 3.3.9.1. However, there will be a separate block for each phase containing ...

A single phase
Toby, B. H.  International Tables for Crystallography (2006). Vol. G, Section 3.3.9.1, p. 128 [ doi:10.1107/97809553602060000735 ]
A single phase 3.3.9.1. A single phase When a single set of diffraction measurements is used to model a single phase, a pdCIF will usually contain only one block. There will be several important loops present. One loop will contain atomic parameters, such as coordinates. The unit cell must also be ...

Use of pdCIF for Rietveld refinement results
Toby, B. H.  International Tables for Crystallography (2006). Vol. G, Section 3.3.9, pp. 128-129 [ doi:10.1107/97809553602060000735 ]
... of diffraction data, and for multiple data sets and phases (Toby et al., 2003). It is valuable for the CIF ... optimally at more than one magnification level. The program pdCIFplot (Toby, 2003) plots the observed and calculated powder-diffraction intensities in ... shown in the CIF in Example 3.3.7.1. The program GSAS2CIF (Toby et al., 2003) can create CIFs for multiple sets ...

powered by swish-e
























































to end of page
to top of page